Preparation of your pool site before installation is vital to ensure your new pool liner looks great and fits well. Ensure the area around your pool site is free from Nut Grass. If you suspect Nut Grass, a good quality suitable poison should be used to kill the grass. Ensure the sand base is at least mm deep over the entire base of the pool. A cove will need to be created all the way around the wall of the pool at least mm high.
Tools Needed:
suitable drill and bits(cordless is recommended)
rubber mallet
wet/dry vacuum cleaner
stanley knife
ladder to enter and exit the pool
pvc tape
screed (this can just be a flat piece of timber about mm long)
soft broom
small tube of vinyl safe silicone
level
some black plastic
your new liner
Step 1. Place new sand inside the pool if required and screed to smooth the sand. This can be done with a garden rake or a piece of timber. Once the sand floor of the pool is completely smooth, compact it by tamping or rolling. Sprinkling water onto the sand will help the compaction. We recommend using a fine broom to remove any compaction marks (and foot prints) ensuring a good, smooth finish for the liner.
Step 2. With a cloth or soft broom, clean the walls of the pool to remove any sand and metal filings. We recommended using a PVC insulation tape or similar tape over the wall join bolts on the inside wall of the pool. It is also advisable to place a ground sheet or black plastic sheet between the sand and liner. This is secured to the pool wall above the sand cove with tape. Remove top copings or small round metal capping from the pool .
Address: 21-23 Access Ave, Yatala, QLD 4207
Yatala, QLD. C.P.: 4207
tel:
0738xxxxxx View Phone numberWeb: http://www.fabricsolutions.com.au/above-ground-pool-liner-installation-guide/