Tank Liner installation

When installing a fitting, ensure that there is sufficient slack material all around the penetration. There should be no stretching of material near or at the fitting. Locate where your fitting needs to be positioned and cut a hole smaller than the threaded pipe for you fitting into the tank liner.

Once this has been done, put a bead of potable grade silicon around the threaded pipe of the fitting (just above the rubber gasket) and push the fitting through the hole of the liner, making sure the fitting goes through the tank penetration to the other side of the tank.

After the fitting has been installed from the internal side of the tank to the external side, tighten the second nut of the fitting against the outside of the tank, making sure that the fitting is as tight as possible.

Go back inside the tank and put a big bead of silicon all the way around the outside of the circumference of the fitting, as this will create an extra layer of waterproofing. Once this has been done, let the silicon dry and start checking the liner.

Address:
21-23 Access Ave, Yatala, QLD 4207
Yatala, QLD. C.P.: 4207
tel: 0738xxxxxx View Phone number

Web: http://www.fabricsolutions.com.au/duratank-water-tank-liner-installation-guide/

ads